Description
CALAUTOTOOLFluke RPM80 Inductive Pick-Up/External Trigger – Provides RPM readings.- Best used with Fluke 88 V/A KitFLUKE TL28A – Automotive Test Leads SetLarge jaws, long leads and a piercing needle inside the jaws. Solid, spring-loaded copper clips with a wide 12.7 mm (.50″) jaw opening and serrated teeth. Large piercing needle for penetrating larger gauge wires located inside the jaws. 1.5 m (60″), silicone-insulated leads, useable from -80 °C to +70 °C (-112 °F to +158 °F). Rated for 30 V, 10 A. One red, one black.FLUKE TL26A – 60 in. 5 way test leads set60″ (1.5m), silicone-insulated leads, useable from -80°C to +70°C (-112°F to +158°F). Rated for 30V, 8A. One red, one black.5 ways to connect:U-shaped nose for blade-shaped terminalsNotched jaw for gripping screw heads, bare wire or terminalsSerrated teeth for gripping threaded or wire-wrapped terminalsCluster of sharp needles for piercing small gauge (#22-#28 AWG) wiresLarge piercing needle for penetrating larger gauge wiresFluke AC220 SureGripTM Alligator ClipsSureGrip™ accessories are designed to improve steadiness in slippery hands. Rubber overmolded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they can focus on making an accurate measurement.One pair (red, black) of small, insulated, nickel plated jawsBlunt tip grabs round screw heads up to 9.5 mmRecommended for use with TL222 and TL224 test leadsCAT IV 600 V, CAT III 1000 V, 10 A rating. UL listedFluke TP88 Rigid Back Probe PinsBetter than a test probe alone – these two inch long rigid back probe pins easily pass between the weather pack seal and wire. A sharp point ensures good contact to the electrical connector, and the pin’s insulation protects it from shorting to other wires.Slides onto test probes measuring 2 mm (0.08 inches)Tested to 60 V DCFluke TP220 SureGripTM Industrial Test ProbesSureGrip™ accessories are designed to improve steadiness in slippery hands. Rubber overmolded surfaces and finger-hugging curves give the user a comfortable, reliable grip on the accessory so they can focus on making an accurate measurement.One pair of industrial test probes (red, black)Sharp, 12 mm stainless steel tip provides reliable contactFlexible finger barrier improves gripRecommended for use with TL222 and TL224 test leadsCAT II 1000 V, 10 A rating Fluke TL222 SureGripTM Silicone Insulated Test LeadsDMM test leads (red, black) with safety shrouded, standard diameter banana plugsRight angle connector on both endsReinforced strain relief1.5 meter silicone-insulated wire resists heat and coldCAT IV 600 V, CAT III 1000 V, 10 A rating. UL listed
